Topics

Do you all find the stock value for sensitivity to be suitable for your instruments? I use it at the front of my chain, and find that I'm having the sustain set almost at max. If I use a low output guitar, the effect seems too subtle. Perhaps I got a higher resistance vactrol than average.

A few manufacturers use long pin pots to accommodate the stomp switch and 1/4" jacks to all be pcb mounted. I'm wondering if a pcb mount toggle or slide switch exists that can also be used on such a board. The switch would need to be panel accessible like the pots/stomp switch. The long pin pots have a clearance of 20.7mm from top of board to the enclosure. I've found a new series by e-switch that accommodates this height, but nobody seems to have them in stock.

The tech 21 pedals have a slide switch like this, but I can't find the part number:
http://www.talkbass.com/threads/show-your-pedal-guts.653387/page-6

I was wondering if anyone has had any recent experiences with Pedal Parts Plus UV Printing.

Some people were experiencing problems in the beginning:
http://www.madbeanpedals.com/forum/index.php?topic=9110.60

Have they sorted out the inconsistencies? Would you recommend the service, or is Mammoth screen printing preferred?