Small Clone using my PCB design. Added the obligatory mods: depth pot and rate led.
Everything just fits in this CamdenBoss enclosure. Had to use Lumberg style sockets. Both jacks and DC. Otherwise I'd have to go up to an 125B enclosure.
I will probably change the knobs. I'm waiting for an order to arrive then I'll compare them to these.
I was supposed to have used a Fresnel for the bypass LED but I was overzealous with my drilling
I used a clear adhesive label, instead of decal paper, for the first time. It's easier to work with than decal but you only have one chance to lay it on the enclosure! If you get your alignment wrong you'll have to rip it off, clean the glue off and start again with a new label.
I sprayed it with a few coats of Rust-Oleum Polyurethane Finish and left it to dry under the British sun (it only appears a few times a year so I had to be quick!!!)
This now has a permanent spot on my pedal board
Everything just fits in this CamdenBoss enclosure. Had to use Lumberg style sockets. Both jacks and DC. Otherwise I'd have to go up to an 125B enclosure.
I will probably change the knobs. I'm waiting for an order to arrive then I'll compare them to these.
I was supposed to have used a Fresnel for the bypass LED but I was overzealous with my drilling
I used a clear adhesive label, instead of decal paper, for the first time. It's easier to work with than decal but you only have one chance to lay it on the enclosure! If you get your alignment wrong you'll have to rip it off, clean the glue off and start again with a new label.
I sprayed it with a few coats of Rust-Oleum Polyurethane Finish and left it to dry under the British sun (it only appears a few times a year so I had to be quick!!!)
This now has a permanent spot on my pedal board