Just built the Stagefright Phaser and added the Sweep Pot, thanks to Jon Patton.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Build Reports / SWAH V3
August 25, 2014, 07:51:18 AM
Hi Everyone,
Here is my build for the SWAH V3.
The decay on my build is not responding then I realized I haven't put on the jumper wire from Trim 2 (Bias) to 78L05's out. But I'm not sure if that's what cause the decay's response. It's working as it should except for it though. I will hook it up when I reach home.
Anyway, here are the photos.
Enjoy!
Here is my build for the SWAH V3.
The decay on my build is not responding then I realized I haven't put on the jumper wire from Trim 2 (Bias) to 78L05's out. But I'm not sure if that's what cause the decay's response. It's working as it should except for it though. I will hook it up when I reach home.
Anyway, here are the photos.
Enjoy!
Pages1