I haven't been around the madbean forum in many years, so let me know if I'm breaking any rules/culture here
I'm planning to make an Echo-matic, but I think this PCB is starting to get a little too complex for me to fake it with perfboard. I don't really have a setup to make PCBs (and kind of don't want to get into that hobby), so I was hoping someone with an etching setup might be able to help me out. I'll obviously pay you for your time/materials. The PCB transfer is at the bottom of this page:
![](http://web.archive.org/web/20120418024426/http://moosapotamus.net/IDEAS/Echo-Matic_a.gif)
Here is a cleaner image (for 600 dpi), it may need to be reversed depending on your transfer method:
I'm planning to make an Echo-matic, but I think this PCB is starting to get a little too complex for me to fake it with perfboard. I don't really have a setup to make PCBs (and kind of don't want to get into that hobby), so I was hoping someone with an etching setup might be able to help me out. I'll obviously pay you for your time/materials. The PCB transfer is at the bottom of this page:
![](http://web.archive.org/web/20120418024426/http://moosapotamus.net/IDEAS/Echo-Matic_a.gif)
Here is a cleaner image (for 600 dpi), it may need to be reversed depending on your transfer method:
![](http://1.bp.blogspot.com/-MHPQT-S2A0w/VTwzUt7-kuI/AAAAAAAAA-E/u7t__jVWaDw/s1600/Echo-Matic_Delay_Layout_600dpi.png)