Topics

Built the Egodriver, and its squealing and feeding back like crazy.  My soldering iron was too hot so it took off the pos pad of C10 and also the led.  I removed C10 and soldered wires to the top side of the board for the led.  Lights up, gets bypass, OD works but theres an overpowering squealing and chaos going on.  It can be controlled by the gain pot.  Could be a cool noise device but I really wanted an OD.  Any suggestions?  I remember I asked about C10 previously, I think it was fine to leave off.  Is my gain pot broke maybe?  Anything I should try? 

So I lifted the positive side of C10 on both sides of the Egodriver board somehow.  (was desoldering out 16v electrolytics to put in 25v). Is this board dead now or can I fix it somehow?  The whole board is populated, haven't done the wiring yet, this just happened now.  What should i do.  Thanks.   

Hey, I've checked demos for both of these and they both sound good.  People say the Eternity has more gain but I hear some heavy bands using the OCD and it works fine for them.  Just wanted to see if anyone here has had the chance to do a comparison with the Neutrino and Egodriver.

My guitar has humbuckers and I run through a tube recto amp.  Looking to build a good overdrive that can go between a cleanish boost to borderline distortion and produce good harmonics.  What do you guys think?

Was just wondering why the slambox has more components than the other layouts I've seen for the sh0.  Has the real sh0 changed design or are these custom mods?