Topics

I just finished the mangler build I've been working on and I plugged a battery in but am not getting a reading when I try to bias the pedal or when I try to play through it. The signal goes through but no sound comes out when it is switch on. Only thing that is happening is the battery gets hot.

I used the standard MB wiring diagram. Only thing I haven't hooked up yet is the led.
I can send pictures by email if anyone can help out. I'm on a phone so I can't upload to the forum.

Thanks
Dave

I'm building a fuzz with the mangler pcb and am not 100% sure which in/out jacks to use. I'm seeing many posts that refer to using a stereo for the in and a mono for the out. Is this needed or can I just use 2 mono jacks. Is it the same for all pedals or do certain circuits require different combinations?

Any help for a newbie is greatly appreciated. Thanks

Should I use 1/2 watt or 1/4 watt resistors? I've read that 1/2 watt may produce more noise/hum. Was the pcb designed to fit 1/2 watt?

Thanks in advance.

Hi everyone. I'm new to all this and am starting with a mangler. Anyone have a drill template for a 1590B box if I'm using on board pots?