Messages

I've always had a problem with etching the boxes (never get the toner to transfer well), but you can etch it the same way you do a board.  Then you just paint it and then sand off the paint, leaving the paint only in the grooves you etched.

I have the 25K, but its linear not audio tapered.  IDK if that will make a huge difference.

Does anyone know where to get a 9mm 20ka pot for the mid pot on the kokbox?  I have all the other 9mm pots that I got from smallbear, but they dont seem to stock a 9mm 20ka pot.

The only pcb I could think of that would make sense, that everyone could use is a  3pdt true bypass board.  But, I agree with junkemail86, I received a bonus once

I noticed on my last order that some of the pcb's are single sided, and that the traces are silver.  Is that because the copper is plated silver, or are they just silver clad boards.  Just curious b/c I would like to do it to the boards that I make if possible.

Futerlec takes forever in shipping.  I ordered from them on the 8th and i just recieved it recently.  I order from tayda there much quicker and pretty fast considering they ship from china to MA and then to you.  Funny thing about small bear is if I order from tayda and small bear at the same time I receive them at about the same time and tayda is in china and small bear is maybe a half an hour drive from my house, lol.  I have contemplated asking small bear if i could just pick up my order.