Thanks for the reply, I will try that tonight. I was hoping there was an issue there because neither pedal works. Oh well, back to the drawing board.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Questions / (2x) 8-ball voltage at IC pin #3
January 20, 2016, 02:21:41 PM
My father and I have both attempted to build the 8-ball. We both reached the point where the board was completely wired and ready to test. We took voltage readings on the IC for both builds and everything was within acceptable tolerance EXCEPT for pin #3 - it is reading ~1.8v (documented value is 4.2v).
The *really* maddening aspect of this is that there are only 3 components: R1 (2M2), C1 (56n), and R2 (1M) and we have checked, double-checked, re-flowed, re-soldered, etc.
Help! Thanks.
The *really* maddening aspect of this is that there are only 3 components: R1 (2M2), C1 (56n), and R2 (1M) and we have checked, double-checked, re-flowed, re-soldered, etc.
Help! Thanks.
Pages1