Print Page - Three-in-One Grounding Question (with a twist)

Title: Three-in-One Grounding Question (with a twist)
Post by: spaceboss on January 02, 2013, 09:18:22 PM

If I'm putting a bunch of circuits in one box, and one of them is a PNP Zygote powered by a Road Rage (no battery), are there any grounding particulars I need to be concerned with?

Is there any problem with the Zygote board/switch grounds going to the same place (output sleeve) as a buffer, and a green ringer clone?

Happy New Year!

Title: Re: Three-in-One Grounding Question (with a twist)
Post by: jkokura on January 02, 2013, 09:33:33 PM

The Zygote should connect to the rest of ground THROUGH the Road Rage board. Go like this: DC Jack + and GND to Road rage - Road rage -9V to Zygote and GND to Zygote. The DC jack GND should connect to the rest of the circuit's ground.

Jacob

Title: Re: Three-in-One Grounding Question (with a twist)
Post by: spaceboss on January 02, 2013, 10:22:47 PM

Thanks Jacob!

madbeanpedals::forum

Projects => General Questions => Topic started by: spaceboss on January 02, 2013, 09:18:22 PM