Print Page - Footswitch PCB

Title: Footswitch PCB
Post by: crashguitar on April 23, 2010, 03:16:58 PM

I was looking through some of the BYOC instructions and I noticed that they were using a small PCB for wiring/attaching a 3pdt footswitch (I found in in their tremolo instructions). Seems like something like this might make wiring the switch a lot easier. Any thoughts on making something similar?

Title: Re: Footswitch PCB
Post by: neiloler on October 07, 2010, 05:45:54 PM

I've used this little jobbie from Small Bear and it works well: http://www.smallbearelec.com/Detail.bok?no=870

Title: Re: Footswitch PCB
Post by: CRBMoA on October 07, 2010, 09:19:29 PM

Also available here (http://www.guitarpcb.com/apps/webstore/products/show/1343792)

Title: Re: Footswitch PCB
Post by: crashguitar on October 07, 2010, 11:13:49 PM

I found them at Smallbear, too. I have used it and really liked it.

Title: Re: Footswitch PCB
Post by: Haberdasher on October 09, 2010, 03:25:51 PM

I etch my own.

Title: Re: Footswitch PCB
Post by: crashguitar on October 10, 2010, 03:43:51 AM

Would you be willing to share the artwork?

Title: Re: Footswitch PCB
Post by: NoizeD on December 10, 2010, 11:52:28 AM

Quote from: crashguitar on October 10, 2010, 03:43:51 AM
Would you be willing to share the artwork?

if you want to etch your own i suggest you to check this out ---> http://topopiccione.atspace.com/PJ22TPCAssemblySystem.html

Scroll down for pcbs and layouts

madbeanpedals::forum

Projects => General Questions => Requests => Topic started by: crashguitar on April 23, 2010, 03:16:58 PM