I've been working on green board d2 dynacomp modding to ross specs. Anyone on here done this before? Is there already a discussion thread Ive missed? Would love some info, specs, or feedback.
Mike
I built the tonepad version of the Ross comp and then later imparted a mod to switch between Dyna and Ross. I'm not sure how close the schem is to the MXR board, but the difference between the two is only four caps to ground and a couple of resistors http://tonepad.com/project.asp?id=10 (http://tonepad.com/project.asp?id=10) Not sure if this helps, but that's the route I went. Good luck!