I'm trying to source the on-board 9mm pots for an etched Zombii board, and I'm not sure where to find them. Looking at Mouser there's a ton of options, but I'm a little worried I'm going to pick the wrong one/s. Can anybody tell me the specific part number/s I need to find for the 5K and 10K pots for this project?
Thanks very much in advance.
The zombie in the etchers paradise area uses 16mm pots
I should specify, this is an older version of the etched board that is very long and thin, and takes the 9MM pots. I hope that helps.
Quote from: MarkL on December 04, 2021, 05:43:59 PM
I should specify, this is an older version of the etched board that is very long and thin, and takes the 9MM pots. I hope that helps.
Did you look at Tayda? Those are the ones you want. Option B: You can still you use 16mm, just wired them instead of board mounting them.
Sent from my iPhone using Tapatalk
Tayda has the 10k pots, but not the 5k. You could put a 5k1 resistor in parallel with 10k to make a 5k pot.
https://www.taydaelectronics.com/potentiometer-variable-resistors/rotary-potentiometer/tayda-10k-ohm-linear-taper-potentiometer-round-shaft-pcb-9mm.html
Thank you so much...I think that will do the trick really well. Appreciate the help!
Sometimes, I would leave it the larger value pot just to see what kind of diy magic it makes.
Sent from my iPhone using Tapatalk