Hi folks...
I etched a Wolfshirt and a Sunking. Wondering if the component numbers that are listed under the fabbed version of the Wolfshirt match up to the etched version... since there is only one list.
I discovered after mostly populating the Sunking that there were 2 seperate numberings :'( and (alas) I used the one under the Fabbed version...
thanx!
Just followed the first few connections up to about R6 and my guess is they are the same component numbering.
Thank you Dr.!
Yeah... I guess the way is to check the schematic against the tracing..
cheers
Quote from: clangmeister on December 05, 2011, 10:22:31 PM
Thank you Dr.!
Yeah... I guess the way is to check the schematic against the tracing..
cheers
Yes its kinda tedious at first but gets easier with more practice. I actually was comparing the two layouts to each other :)