Print Page - Eqd ghost echo predelay

Title: Eqd ghost echo predelay
Post by: Thewintersoldier on October 25, 2019, 07:56:42 PM

Is there a way to dial out the preday completley? Stock has 30ms of predelay with the attack pot at minimum. Ideally I'd like it to start at 0. Thanks
(https://i.imgur.com/IZ7l6XO.png)

Title: Re: Eqd ghost echo predelay
Post by: Aleph Null on October 25, 2019, 09:09:53 PM

The design of the PT2399 is such that it's not really possible to get delay times below 30ms in most builds. You'd have to bypass the delay portion of the circuit with a switch, I think.

Title: Re: Eqd ghost echo predelay
Post by: madbean on October 25, 2019, 09:36:03 PM

Remove R9. From C5, one wire to a 10k resistor, other end of said resistor the the middle lug of an On/On switch. Connected one outer lug of the switch back to the other end of R9 on the board (the end that goes to R13). Connect the remaining lug of the On/On to R11, R10 junction. Switch makes the signal go between passing through the PT2399 or going straight to the BTDR-2.

Title: Re: Eqd ghost echo predelay
Post by: Thewintersoldier on October 26, 2019, 09:43:25 PM

Thanks Brian, I'm definitely gonna try that out. Im gonna breadboard it after I build my rub-a-dub deluxe.

madbeanpedals::forum

Projects => General Questions => Topic started by: Thewintersoldier on October 25, 2019, 07:56:42 PM