I haven't been around the madbean forum in many years, so let me know if I'm breaking any rules/culture here
I'm planning to make an Echo-matic, but I think this PCB is starting to get a little too complex for me to fake it with perfboard. I don't really have a setup to make PCBs (and kind of don't want to get into that hobby), so I was hoping someone with an etching setup might be able to help me out. I'll obviously pay you for your time/materials. The PCB transfer is at the bottom of this page:
(http://web.archive.org/web/20120418024426/http://moosapotamus.net/IDEAS/Echo-Matic_a.gif)
Here is a cleaner image (for 600 dpi), it may need to be reversed depending on your transfer method:
(http://1.bp.blogspot.com/-MHPQT-S2A0w/VTwzUt7-kuI/AAAAAAAAA-E/u7t__jVWaDw/s1600/Echo-Matic_Delay_Layout_600dpi.png)
It's not bad etiquette at all. In fact, this sort of thing is encouraged! ;D
There are several folks here who can etch you a board.
This thread might get more attention in the Buy / Sell / Trade subforum, but there's really no harm in having it here.
Haberdasher is your man for one off etchings such as these (assuming he still does it....)
Hey, yes I still do it.
In fact I have made that one for someone before.
Give me a pm if interested.
cheers
Somebody else already offered. I'll get back to you if I need more in the future..
Thanks
Mike