Hi
Anyone have any ideas how easy it would be to make the Dig Dug trem rather than wah? Like the seek trem / tremorama?
Thanks
This procedure might get you close but is untested.
Decrease R2 to 10k
Increase R3 to 4M7
Remove R4, R5, R6, R9, R10, C3, C4, C5, C6, C8 and C11
Put jumpers in place of C6, C5 and R9
Leave the "Filter" pot off
This is pretty close to the tremolo section of the Quadrovibe. If it has too much gain, put R9 back in.
Quote from: madbean on August 21, 2011, 03:45:14 PM
This procedure might get you close but is untested.
Decrease R2 to 10k
Increase R3 to 4M7
Remove R4, R5, R6, R9, R10, C3, C4, C5, C6, C8 and C11
Put jumpers in place of C6, C5 and R9
Leave the "Filter" pot off
This is pretty close to the tremolo section of the Quadrovibe. If it has too much gain, put R9 back in.
Heh, cool. Not sure if I will actually do this, as I want the Wah sounds, but its good to know. I suppose I could socket a shit load of the circuit!?
Which not just have a second smaller board for the tremolo and then a switch to go between the two?
Quote from: madbean on August 22, 2011, 12:32:11 AM
Which not just have a second smaller board for the tremolo and then a switch to go between the two?
Id have no real idea how to do that, and I dont have the etching tools :(