Print Page - Re: 3PRR Set-up

Title: Re: 3PRR Set-up
Post by: K3yPr0gg3r on October 04, 2016, 11:59:49 PM

Hi,

I purchased 2 3PRR boards, (3PDT + Road Rage in one), yesterday. I'm building "Faultline", and I want to run it at 18V using my 9V adapter...(so as a voltage doubler). I've included a pic of how I think it might be connect, but not sure.

Also, it states in the build docs, "I need +18v output for my overdrive pedal (or whatever)...
Solder everything except C5, C6, C7, and REG to the Road Rage PCB. Connect your DC jack to the
"DC" pads and take the output from +18/G. Jumper the two C6 pads to connect pin5 of IC1 to ground." So I don't use C5, C7, OR the Regulator if I'm trying to set up a voltage doubler?

Thank you for any help...

Title: Re: 3PRR Set-up
Post by: madbean on October 05, 2016, 12:26:56 AM

J1 and J2 are for soldering input and output jacks. Use S (send) and R (return) for the FX in and out.

Title: Re: 3PRR Set-up
Post by: K3yPr0gg3r on October 05, 2016, 01:56:06 AM

Thanks Brian. I don't need those other components including the regulator when setting up to voltage double?

Title: Re: 3PRR Set-up
Post by: Jebus on October 05, 2016, 07:45:10 AM

Nope, just like the docs say: C5, C6, C7 and regulator are not needed.

Title: Re: 3PRR Set-up
Post by: K3yPr0gg3r on October 05, 2016, 11:54:29 PM

Cool... And here I thought it was going to be difficult! Thank you...

Title: Re: 3PRR Set-up
Post by: K3yPr0gg3r on October 06, 2016, 12:24:40 AM

Sorry, just to confirm. J1 is IN and J2 is OUT or visa versa? On every other breakout I have IN is always on the left.

Thank you

Title: Re: 3PRR Set-up
Post by: madbean on October 06, 2016, 12:46:19 AM

J1 is in.

madbeanpedals::forum

Projects => How Do I? Beginner's Paradise. => Topic started by: K3yPr0gg3r on October 04, 2016, 11:59:49 PM