hi friends,
this spdt is ok for the fulldrive? http://www.smallbearelec.com/Detail.bok?category=ALL&keyword=spdt&no=792¶m_referer=http%3A%2F%2Fwww.smallbearelec.com%2FCategories.bok&searchpath=2936990
if not, what spdt I have to buy?
That looks like the right one. You'll also need one of the DPDT switches w/ the on/on/on configuration. Like this one->http://www.smallbearelec.com/Detail.bok?no=900
Edit: Just saw you got a reply in the next thread. :)
yes bigmufff,
but thank you however!
two opinions is better than one! :)
the dpdt is already advised in the project, so my doubt was about the spdt.
now I can order both!
thanks again!
No problem! I didn't see that link posted on the doc originally. I was going by the BOM. Here's a great article about switches so you'll have more idea what your looking for. :)
http://www.beavisaudio.com/techpages/Switches/
I'd also read the rest of that site!!
wow great page! thanks buddy
so if wanna use a switch in an other project, a phaser, and I need the possibility to off the 22k resistence of feedback, I could use a spst?
If your disconnecting something from say ground, you can use the SPST switch that only has 2 lugs since your trying to omit a value and it won't create an open. If you wanna replace it with a jumper use the 3 lug spst switch.
:) thanks
so I'd use this... http://www.beavisaudio.com/techpages/Switches/SwitchingComponents.gif
spdt with 3 lugs using a jumper and the 22k.
Yup easy as that! That site really has a wealth of information. I revisit every few months and pick up more technical stuff.
you're right, it's very useful and easy!