I was looking at the Klon schematic and noticed there are components in the path when the effect is off so can I just leave those out?
The original schematic:
(http://images.imaginekitty.com/KlonCentaur.sch.gif)
Can I leave out these bits:
(http://images.imaginekitty.com/KlonCentaurTB.sch.gif)
and then connect the output pot wiper to the out jack?
i think you'd be interested in the 2015 kingslayer
That looks right. I did the same thing with a cheap Klon kit I got off eBay.
Andrew.
Quote from: Lubdar on February 22, 2016, 02:11:46 AM
i think you'd be interested in the 2015 kingslayer
It would probably be an easier path but I'm trying to learn to use Eagle and modify circuits. :) It's sure a lot of fun.
Quote from: electrosonic on February 22, 2016, 06:54:12 AM
That looks right. I did the same thing with a cheap Klon kit I got off eBay.
Andrew.
Great! I'm going to breadboard this out if it will fit. So far it looks like it would be easier to submit it to oshpark though. ;)