I built the board up carefully (on perf) - am an experienced builder, have retouched all my solder joints, have looked for bridges, have been over the project layout multiple times, have triple checked all my component values. Took the guts straight from another build, so the stomp switch, dc jack, input & output jacks & wiring are all known working parts. Yet I have no output at all (bypass works).
I guess I'm off to measure voltages next, though may replace all the (socketed) 5457's first and give it a run.
Has anyone built this project?
Yeah, I would check to make sure power is getting to the board first. I have etched a board and have all the components, just need to get an enclosure to put it in. I'll try and put mine together sans enclosure and report back in the next few days. Keep us posted!