Hi all i got a rampage fron a friend fried by someone trying to repair the board bit lift all pots pads and in/out jacks and power jack so i email at jim in rocktron and he gave me the Schematic for the pedal so maybe can try a layout bit in not so good at layouts maybe somebody can help me at some points when ir maybe somebody its interested in making the PCB too
edit. schematic uploaded
Hello! newbie here!
I was editing and converting on EASYEDA the rampage distortion diagram and i want to share with you.
https://easyeda.com/ningenisu/rampage
https://easyeda.com/editor#id=|e1d44630bda447518b842800943b557f
I dont know much, maybe i made some mistakes (like the "jumper"... can be a switch???)
I have a question about the in jack (z2), the ring was wired to ground?
Best regards!