high :) I'm new
just wondering if anyone has a chance to look over
some pics before I continue
wondering if the 100pf ceramic cap(C2) is ok to use
or should i change to mica or poly?
also using the SmallBear germs.... anyone have
opinions on these for this layout?
thanks
http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/serendipity002.jpg (http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/serendipity002.jpg)
http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/serendipity001.jpg (http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/serendipity001.jpg)
[attachment deleted by admin]
The ceramic cap is fine for the 100pF. I'm sure if you got the diodes from small bear and they are the specified value or equivalent they will be fine too. Looks like a good, clean build!! Great job!
Thanks for looking irmcdermott
will move on and try my hand at drilling the housing next
using 24mm pots so will try cramming
will be going slow,but will post more asap
thanks again
great! keep us posted! just take your time... i know on my first few builds i rushed everything and the result was no good!
Few more pics of slow progress
template I used was off a little
pot holes are off to 1 side a little
but close enuff 4 rock n roll
plz let me know if something looks wrong
thanks
(http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/serendipity005.jpg)
(http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/serendipity004.jpg)