So I've been building some more delays as of late, and I'm wanting to make one that has less of the delay on the mix knob. I've been using 100K pots, would I get less delay in the mix if I upped the value to something like 250K?
Quote from: GammaFlex on October 08, 2014, 02:20:57 PM
So I've been building some more delays as of late, and I'm wanting to make one that has less of the delay on the mix knob. I've been using 100K pots, would I get less delay in the mix if I upped the value to something like 250K?
The mix pot typically is just a voltage divider.
But following are usually a cap and a resistor feeding the wet signal into a mixing op amp.
Increase that resistor and your max mix level will decrease.