Print Page - EMG DG-20 Pickup Vero Board

Title: EMG DG-20 Pickup Vero Board
Post by: Gilmourisgod on November 10, 2013, 02:31:10 PM

I saw a vero board layout for an emulation of the dg-20 EXG and SPC tone controls someplace, lost track of it. I have an old set of EMG SA pickups, thought I might try my hand at a couple of vero boards. Do you think they would fit in a standard strat control cavity?8

Title: Re: EMG DG-20 Pickup Vero Board
Post by: croquet hoop on November 12, 2013, 01:27:47 PM

I am not sure about vero, but there are PCB and perf layouts available at fsb. The perf layout is 18x23 holes, approx. 45x60 mm. That may be a bit tight, but I think it would fit inside a standard Strat control cavity.

Title: Re: EMG DG-20 Pickup Vero Board
Post by: Gilmourisgod on November 14, 2013, 05:59:07 PM

Sorry, what is "FSB", is that a website? Can you post a link for me? Much appreciated.

Title: Re: EMG DG-20 Pickup Vero Board
Post by: croquet hoop on November 14, 2013, 06:02:59 PM

freestompboxes.org

http://www.freestompboxes.org/viewtopic.php?f=3&t=8433

There's even an eagle file for the schematic. I could try to make make a small pcb for thru-hole components and share it through OSH park, but it wouldn't be verified.

Title: Re: EMG DG-20 Pickup Vero Board
Post by: Gilmourisgod on November 14, 2013, 09:03:51 PM

Thanks Hoop! Guess it's time to register for the FSB forum, been lurking on it for awhile, most of the discussions too advanced for my (extremely) limited electronics knowledge, but I'm not afraid to screw up. I have a spare strat pickguard for ruining perfectly good electronics components handy.

madbeanpedals::forum

Projects => General Questions => Topic started by: Gilmourisgod on November 10, 2013, 02:31:10 PM